Remote Motor Drive
With the CNMC Model RMD-100-5 Remote Motor Drive you can convert the manual mechanism of the CNMC WP-3040, WP-3840 and STP-145M detector positioning assembly to allow detector positioning from outside of the treatment room, adding convenience and significant savings to your data acquisition time.
Installation is easy, since it makes use of existing threaded holes for mounting the motor drive assembly to the detector positioning assembly. Although the installation includes adding two drive sprockets, the hand crank is reinstalled on the motor shaft, thereby retaining the original manual positioning and mechanical counter readout functions.
The control/display module is connected to the drive motor by a 15-meter cable for complete control of detector position from the accelerator console. Its six-digit liquid crystal display indicates the depth position in units of centimeters to 0.001cm. The RUN switch operates the motor drive in a continuous mode, while the JOG switch provides intermittent operation. Both switches control the motor drive in up/down directions, indicated on display as + and - respectively.
Model RMD-100-1 may be specified for adaptation to the existing Med-Tec MT-100 and MT-150 water phantoms. Except for the mounting hardware, all features and technical specifications are indentical to the RMD-100-5.
Model RMD-100-3 may be specified for adaptation to the existing CNMC WP-300 and WP-380 water phantoms. Except for the mounting hardware, all features and technical specifications are indentical to the RMD-100-5.